The BAUR system software is a package for cable testing, cable diagnostics and cable fault location. In combination with BAUR cable fault location, testing and diagnostics systems, it allows efficient monitoring of the condition of cable networks.
VLF cable test, dissipation factor measurement, partial discharge diagnosis and cable fault location
|
Reliable cable fault location, cable testing and diagnostics
- Best possible basis for cost-optimized, condition-oriented maintenance
- Common data management through comprehensive cable database supports actual and trend analysis
- Conclusive presentation of measurement results
- Modern, multi-lingual operating concept
|
The heart of the measurement system.
Cable Testing
|
|
- Commissioning, maintenance and recommissioning tests
- Selectable test voltages: square wave voltage and DC voltage (+/-)
- Manual or automatic testing
- Simple programming of test sequences
- Variable frequency from 0.01 to 1 Hz
- Automatic saving of measurement results
|
The heart of the measurement system.
Tan-delta-diagnostics
|
- Identify cable insulation ageing at an early stage, independent of load
- Evaluation criteria for XLPE and PILC cables
- Measurement data exchange possible with frida/viola TD portable devices
- Simple programming of diagnostic sequences
- Measurements can't be simpler. Combined w/ cable data, history and partial discharge measurement, reliable assessment of cable condition is possible
|
The heart of the measurement system.
Partial discharge measurement
 |
- Locate vulnerabilities in the cable before a fault occurs
- Combined with cable data, history and a tan delta measurement, reliable cable condition assessment is possible
- AutoGain for easy calibration
- Automatic mode enables automated recording of partial discharge locations, inception and extinction voltage
- Frequency filter makes good quality assessments possible even with sources of interference
- Phase-resolved display of partial discharges
- Integrated VLF testing possible
|
The heart of the measurement system.
Cable fault location
 |
- Unique, proven SIM/MIM for locating 98 % of faults
- "Easy" mode for common faults
- Expert mode also for difficult cases
- Methods:
- Determination of fault resistance with the resistance measurement
- Measure low ohmic faults and cable interruptions with the TDR measurement including joint search mode
- Locate high ohmic and intermittent faults with the SIM-MIM method
- The method for extremely long cables - impulse current method
- Even faults that flash over above 32 kV can be located – decay method
- Complex networks require the differential, impulse current and decay methods
|
The heart of the measurement system.
Report
 |
- Automatically generated
- Displays cable data and measurement results
- Well-organised graphics
- Customizable
|